Advertisement
∫ Playback and editing on a PC
Software for image playback or editing is not supplied with this product.
•
To play back or edit still pictures, use standard software.
•
To play back motion pictures, use the following software:
QuickTime/iTunes, provided by Apple
(Software supporting MP4 format is required.)
•
If software is not installed on your PC, download it from the website of the software provider.
•
For information on how to use software, contact the software provider.
Troubleshooting
If the problem is not resolved, it may be improved by selecting [Reset] on the [Setup] menu.
The charging lamp blinks.
•
This phenomenon occurs when charging in a location where the temperature is very high or
very low.
> Reconnect the USB connection cable (supplied) in a location where the ambient
temperature (and the temperature of battery) is in a 10 oC to 30 oC (50 oF to 86 oF)
range, and try charging again.
Striping or flicker may appear under lighting such as fluorescent lighting and LED
lighting fixture.
•
This is characteristic of MOS sensors which serve as the camera's pickup sensors.
This is not a malfunction.
Reddish horizontal streaks appear on the monitor during recording.
•
This is characteristic of MOS sensors which serve as the camera's pickup sensors. It
appears when the subject has a bright part. Some unevenness may occur in the surrounding
areas, but this is not a malfunction.
It is recorded in still pictures or motion pictures.
A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.
(General tips for using a Wi-Fi connection)
•
Use within the communication range of the device to be connected.
•
Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
operated nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently away
from the device.
•
When the battery indicator is flashing red, the connection with other equipment may not start
or the connection may be disrupted.
(A message such as [Communication error] is displayed.)
(About a wireless access point)
•
Check if the wireless access point to connect is in operating state.
•
The camera may not display or connect to a wireless access point depending on the radio
wave condition.
–
Move this unit closer to the wireless access point.
–
Remove the obstacles between this unit and the wireless access point.
–
Change the direction of this unit.
–
Change the location and orientation of the wireless access point.
–
Perform the [From List].
•
It may not display even if the radio waves exist depending on the setting of the wireless
access point.
> Check the settings of the wireless access point.
> When the network SSID of the wireless access point is set not to broadcast, the wireless
access point may not be detected. Enter the network SSID to start the connection or
enable the SSID broadcast of the wireless access point.
•
Connection types and security setting methods are different depending on the wireless
access point. (Refer to the operating instructions of the wireless access point.)
•
Is the 5 GHz/2.4 GHz switchable wireless access point connected to other equipment using
the 5 GHz band?
> The use of a wireless access point that can use 5 GHz/2.4 GHz simultaneously is
recommended. It cannot be used simultaneously with this camera if it is not compatible.
It takes long time every time to connect to a smartphone/tablet.
•
It may take longer time to connect depending on the Wi-Fi connection setting of the
smartphone/tablet, but it is not a malfunction.
Transmission of the image fails midway.
•
Is the size of the image too large?
> Reduce the size of the still picture, then transmit.
> Image cannot be transmitted when the battery indicator is flashing red.
Please refer to "Owner's Manual for advanced features (PDF format)" for details.
Specifications
Specifications are subject to change without notice.
Digital Camera: Information for your safety
Power Source:
DC 5 V
Power Consumption:
1.5 W (When recording)
1.0 W (When playing back)
Camera effective
16,000,000 pixels
pixels
Image sensor
1/2.33q MOS sensor, total pixel number 17,500,000 pixels,
Primary color filter
Lens
Optical 20k zoom, fl4.3 mm to 86.0 mm (35 mm film camera
equivalent: 24 mm to 480 mm)
Wide: F3.3 to F8.0
Tele: F6.4 to F8.0
Image stabilizer
Optical method
Focus range
Normal
Macro/
Intelligent auto/
Motion picture
Scene Mode
50 cm (1.6 feet) (Wide)/2.0 m (6.6 feet) (Tele)
to ¶
3 cm (0.098 feet) (Wide)/1.0 m (3.3 feet)
(Tele) to ¶
[5k to 7k is 2.0 m (6.6 feet) to ¶]
There may be differences in the above
settings.
Shutter system
Electronic shutteriMechanical shutter
Minimum Illumination
Approx. 10 lx (when i-low light is used, the shutter speed is 1/30th
of a second)
Shutter speed
4 seconds to 1/2000th of a second
[Starry Sky] Mode: 15 seconds, 30 seconds
Exposure (AE)
Program AE (P)/Aperture-Priority AE (A)/
Shutter-Priority AE (S)/Manual Exposure (M)
Metering mode
Multiple/Center weighted/Spot
Monitor
3.0q TFT LCD (3:2)
(Approx. 460,000 dots) (field of view ratio about 100%)
Microphone
Monaural
Speaker
Monaural
Recording media
Built-in Memory (Approx. 70 MB)/SD Memory Card/SDHC
Memory Card/SDXC Memory Card
Recording file format
Still Picture
JPEG (based on "Design rule for Camera File system", based on
"Exif 2.3" standard)/DPOF corresponding
Motion pictures
MP4
Audio compression
AAC
format
Interface
Digital
"USB 2.0" (High Speed)
Analog video
NTSC
Audio
Audio line output (monaural)
Terminal
[AV OUT/DIGITAL]
Dedicated jack (8 pin)
[HDMI]
MicroHDMI TypeD
Dimensions
Approx. 106.8 mm (W)k62.2 mm (H)k32.4 mm (D)
(excluding the
[4.21q(W)k2.45q(H)k1.28q(D)]
projecting parts)
Mass (weight)
Approx. 250 g/0.55 lb (with card and battery)
Approx. 224 g/0.49 lb (excluding card and battery)
Operating temperature 0 oC to 40 oC (32 oF to 104 oF)
Operating humidity
10%RH to 80%RH
Language select
[ENGLISH]/[ESPAÑOL]
Wireless transmitter
Compliance standard
IEEE 802.11b/g/n (standard wireless LAN protocol)
Frequency range used
2412 MHz to 2462 MHz (1 to 11ch)
(central frequency)
Encryption method
Wi-Fi compliant WPA
Access method
Infrastructure mode
AC Adaptor (Panasonic VSK0768):
Information for your safety
Input:
110 V to 240 V, 50/60 Hz, 0.2 A
Output:
5 V, 800 mA
Battery Pack (lithium-ion) (Panasonic DMW-BCM13PP):
Information for your safety
Voltage/capacity:
3.6 V/1250 mAh
This product incorporates the following software:
(1) the software developed independently by or for Panasonic Corporation,
(2) the software owned by third party and licensed to Panasonic Corporation and/or,
(3) open source software
The software categorized as (3) is distributed in the hope that it will be useful, but WITHOUT
ANY WARRANTY, without even the implied warranty of MERCHANTABILITY or FITNESS
FOR A PARTICULAR PURPOSE.
Please refer to the detailed terms and conditions thereof displayed by selecting [MENU/SET]
> [Setup] > [Version Disp.] > [MENU/SET].
•
SDXC Logo is a trademark of SD-3C, LLC.
•
HDMI, the HDMI Logo, and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing LLC
in the United States and other countries.
•
QuickTime and the QuickTime logo are trademarks or registered
trademarks of Apple Inc., used under license therefrom.
•
iPhoto, iTunes, Mac and Mac OS are trademarks of Apple Inc.,
registered in the U.S. and other countries.
•
iPad, iPhone, iPod, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
•
Windows and Windows Vista are either registered trademarks or
trademarks of Microsoft Corporation in the United States and/or
other countries.
•
App Store is a service mark of Apple Inc.
•
Android and Google Play are trademarks or registered
trademarks of Google Inc.
•
The Wi-Fi CERTIFIED Logo is a certification mark of the Wi-Fi
Alliance.
•
The Wi-Fi Protected Setup Mark is a mark of the Wi-Fi Alliance.
•
"Wi-Fi", "Wi-Fi Protected Setup", "WPA" and "WPA2" are marks or
registered marks of the Wi-Fi Alliance.
•
QR Code is a registered trademark of DENSO WAVE
INCORPORATED.
This product is licensed under the AVC patent portfolio license for
the personal and non-commercial use of a consumer to (i) encode
video in compliance with the AVC Standard ("AVC Video") and/or (ii)
decode AVC Video that was encoded by a consumer engaged in a personal and
non-commercial activity and/or was obtained from a video provider licensed to provide AVC
Video. No license is granted or shall be implied for any other use. Additional information may
be obtained from MPEG LA, LLC. See http://www.mpegla.com .
TM
/WPA2
TM
Hide quick links:
Advertisement
