Hoover FloorMATE FloorMATETM The Hard Floor Cleaner Owner's Manual page 4

1-3
B
With cord hook (B) to back of cleaner,
push upper handle down onto cleaner.
Insert screw with washer in front of
tank area. Tighten screw with a
Phillips screwdriver.
1-6
D
C
To install brushes, place handle in
upright position. Tilt cleaner back so
that it rests on the floor.
Align post (C) on brush block with
hole (D) on bottom of cleaner. Turn
brushes slightly until post fits easily
into hole.
1-9
While holding nozzle in place, slide
latches inward to lock in place.
4
1-4
Insert two screws into back of handle
as shown. Tighten with a Phillips
screwdriver.
1-7
Press brush assembly firmly to snap
into place.
1-5
Replace clean solution tank by posi-
tioning bottom first. Press latch and
snap top portion into place.
1-8
E
To install nozzle, make sure latches
are out.
Align middle section (E) of nozzle with
opening (F) on cleaner.
Remove cardboard packing insert
from squeegee area on underside of
nozzle.
F