Storage; Cleaning The Nozzle - Hoover FloorMATE FloorMATETM The Hard Floor Cleaner Owner's Manual

4-3
D
C
To replace brushes, first remove solu-
tion tank (Fig. 2-8) and recovery tank
(Fig. 2-16). Set tanks aside. This will
prevent possible leaking.
With handle in upright position, tilt
cleaner back so that it rests on the
floor.
Align post (C) on brush block with
hole (D) on bottom of cleaner. Turn
brushes slightly until post fits easily
into hole.
4-6
F
Slide the two nozzle release latches
(F) outward.
4-9
While holding nozzle in place, slide
latches inward to lock in place.
4-4
Press brush assembly firmly to snap
into place.
4-7
E
F
Remove nozzle (E) by pulling straight
out.
Rinse nozzle under running water.
Remove debris from squeegee (G)
and wipe with a damp cloth.

Storage

Before storing cleaner:
Turn cleaner OFF and disconnect
from electrical outlet.
• Empty and rinse solution and recov-
ery tanks. Allow to air dry.
• Allow filter in recovery tank lid to
dry.
• Set the cleaner for "Dry Vacuuming"
(pedal to "DRY" and Wet Control
switch up).
• Make sure that nothing is pressing
on the nozzle squeegee.
• Do not store cleaner on a wood sur-
face unless cleaner is completely
dry.
4-5

Cleaning the Nozzle

Turn cleaner OFF and disconnect
from electrical outlet.
The cleaner's nozzle (E) can be
removed for easy cleaning.
4-8
H
G
To replace nozzle, make sure latches
are out.
Align middle section (H) of nozzle
with opening (I) on cleaner.
E
I
Continued 11