Select Tool; Before Using Tool; After Using Tool - Hoover SteamVacTM V2TM Owner's Manual

Select tool

Your model includes some combination
of the following tools, but may not
include them all.
3-13
H
G
I

Before using tool

It may be necessary to remove air from
the system ("prime the pump") so the
clean solution will flow to the tool. Follow
these steps:
1. Attach tool to hose and turn the deep
cleaner ON.
2. Put the tool on a hard surface or
against your hand to block off the suc-
tion.
3. Wait a few seconds (can take up to 15
seconds). Then squeeze the trigger and
begin cleaning.
Follow the instructions on pages 13-14
for the appropriate cleaning task.
12
G. SpinScrub™ hand tool has rotating
brushes for extra scrubbing action on
small carpet areas, carpeted stairs and
upholstery. For some models, the
brushes can be removed for converting
to the scrub module.
H. Stair/upholstery nozzle has a built-in
brush to help provide the scrubbing
action some spots may need for
removal.
I. Scrub module with detachable
scrub pad attaches to the base of the
SpinScrub™ hand tool (in place of brush
module). Can be used to scrub stub-
born areas such as scuff marks, dried
spills, and in hard to reach areas on
hard surfaces.

After using tool

Drain suction hose by turning deep
cleaner ON and holding nozzle up for
several minutes. Do not press trigger.
Unplug deep cleaner from electrical
outlet.
Disconnect hose and solution tube
from deep cleaner.
3-15
Drain solution tube by placing round
end in sink and raising nozzle above
your head. Press the trigger.
How to attach tools
3-14
K
Unplug deep cleaner from electrical
outlet.
1. Place handle in upright position and
remove hose from rack.
All tools attach to the hose in the same
manner:
2. Connect tool to hose by sliding it onto
connector until the tab (J) locks it
securely.
Using your thumb, push forward and
up on the latch (K) to remove tool.
3-16
The tool caddy can be removed and
hung on a coat hanger for storage.
J