Hoover QS Quiet Owner's Manual page 19

ser check list
This
appliance was inspected thoroughly and was in good operating condi-
tion when it was shipped from the factory. If a minor problem develops, it
usually can be remedied quite easily when the cause is identified. Accord-
ingly, this check list is provided for your convenience.
Problem Possible cause
A. Cleaner 1. Not firmly plugged in.
won't run 2. No voltage in wall plug.
3. Blown fuse/tripped breaker.
B. Cleaner 1. Bag full.
suction 2. Obstruction in hose, wands
low or nozzle connector.
3. Secondary filter dirty.
4. Bag not opening.
5. Suction regulator control
improperly set.
6. Hose not properly connected
to cleaner.
C. Agitator 1. Hose power cord not firmly
won't run plugged in.
2. Broken or worn belt.
D. Nozzle 1. Low cleaner suction.
won't pick 2. Obstruction in nozzle
connector.
3. Agitator not running.
4. Agitator brushes worn.
If the problem persists, check the Yellow Pages of your telephone book
under "Vacuum Cleaners - Household" for your nearest Hoover Factory
Service Center or Authorized Warranty Service Dealer where approved
HOOVER service and genuine HOOVER replacement parts may be obtain-
ed. The warranty provided with this product has a listing of the Hoover
Factory Service Centers. If you are unable to obtain the information you
need from the Yellow Pages, contact a Hoover Factory Service Center to
find your nearest Authorized Warranty Service Dealer. For service under
warranty, follow the instructions in the Warranty provided with this pro-
duct.
Always identify your cleaner by model number when requesting informa-
tion or ordering replacement parts. (The model number appears on the bot-
tom of the cleaner. 1
If further assistance is needed, contact the Hoover Company Con-
sumer Affairs Department, North Canton, Ohio 44720,
216-499-9200.
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset breaker.
1. Change throw away bag.
2. Remove foreign object.
3. Clean filter.
4. Open bag by pulling folds.
5. Check to be sure suction
regulator is set properly.
6. Insure hose properly
connected.
1. Plug firmly into receptacle
on cleaner base and under-
neath handle.
2. Replace belt.
1. See Item B.
2. Remove foreign object.
3. See Item C.
4. Replace brushes.
18