Toshiba W-704 Service Manual page 64

1-6-4. FL Arm Lever Replacement
1. Remove the door open lever. (Refer to item 1-6-1.)
2. Remove the FL cassette guide assembly. (Refer to
item 1-6-2.)
3. Remove the cassette holder assembly. (Refer to item
1-6-3.)
4. Release the left side claw (1) of the FL arm lever (2)
from the boss (3) of the mechanical deck by pulling
to the arrow direction, and remove the FL arm lever
(2) by pulling to this side from the left side.
Claw (1)
A
FL arm lever (2)
Fig. 1-6-4
5. Replace the part with new one.
6. Mount it in the reverse order of removal.
Note:
• Mount it so that the boss (3) of the FL arm lever (2) is
inserted in the groove of the FL drive slider (4).
1-6-5. FL Drive Slider, Joint Gear 2, FL Cam Gear
and Joint Gear 1 Replacement
1. Remove the door open lever. (Refer to item 1-6-1.)
2. Remove the FL cassette guide assembly. (Refer to
item 1-6-2.)
3. Remove the cassette holder assembly. (Refer to item
1-6-3.)
4. Remove the FL arm lever. (Refer to item 1-6-4.)
5. Remove the FL drive slider (1) by sliding it to this
side slightly and adjusting the mechanical deck boss
(2) portion to the wider groove portion, hole (3) of
the slider, and then remove the FL drive slider (1) by
pulling it out from the hole (3).
FL drive slider (4)
Boss (3)
Worm wheel (10)
Boss (3) of
mechanical deck
Boss (2) of
mechanical deck
Joint gear bracket (5)
Screw (4)
Fig. 1-6-5
6. Turn the mechanical deck upside down.
7. Remove one securing screw (4) on the joint gear
bracket (5), and remove the joint gear bracket (5).
8. Remove the joint gear 2 (6).
Screw (4)
Joint gear 1 (8)
Joint gear 2 (6)
Fig. 1-6-6
9. Remove the FL cam gear (7).
10. Remove the joint gear 1 (8).
11. Replace each part with new one.
Apply an amount of grease on the following portion
of the new parts. (Refer to Figs. 1-6-7 to 1-6-9.)
FL cam gear (7)
Hole (3)
Hole (2)
FL drive slider (1)
Joint gear bracket (5)