Main Parts Replacement - Toshiba W-704 Service Manual

1-6. Main Parts Replacement

1-6-1. Door Open Lever Replacement
1. Release the claw (1) of the door open lever (2)
inserted to the hole at the left lower of the right side
mechanical deck with the door open lever (2) turned
to the arrow direction.
Next, remove the door open lever (2) while lifting it
up from the shaft (3) and the guide (5) portion for the
door open lever (2).
Guide (4)
Fig. 1-6-1
2. Replace the part with the new one.
3. After replacing, mount it in the reverse order of
removal.
Note:
• Mount the door open lever (2) so that it is inserted
along the inside of the guide (4).
1-6-2. FL Cassette Guide Assembly Replacement
1. Remove the door open lever. (Refer to item 1-6-1.)
2. Unlock the lock lever (1), locating on both sides of
the cassette holder assembly (2), by pressing. Then
shift the cassette holder assembly (2) along the guide
groove until the vertical slide position of the cassette
holder guide grooves (A) and (B).
Note:
• Turn the worm wheel (3) clockwise if the cassette
holder assembly (2) is difficult to slide.
3. Remove the FL cassette guide assembly (4) lifting it
up while pressing the claw (5) on both sides of the FL
cassette guide assembly (4) inside.
4. Replace the FL cassette guide assembly with new
one.
5. Mount it in the reverse order of removal.
Door open
lever (2)
Shaft (3)
Claw (1)
Claw (4)
FL cassette
guide assembly (5)
Fig. 1-6-2
1-6-3. Cassette Holder Assembly Replacement
1. Remove the door open lever. (Refer to item 1-6-1.)
2. Remove the FL cassette guide. (Refer to item 1-6-2.)
3. Move the cassette holder assembly (1) to this side.
4. Pull the right side of the cassette holder assembly (1)
this side so that two bosses (2) and (3) come off from
the grooves (A) and (B) of the mechanical deck, and
remove the cassette holder assembly (1) from the
right side by lifting slantwise while releasing the
lock lever (4).
Cassette holder assembly (1)
FL arm lever
Boss (3)
Fig. 1-6-3
5. Replace the part with new one.
6. Mount it in the reverse order of removal.
Note:
• Also, when mounting, mount it while releasing the
lock lever (4).
Lock lever (1)
Guide groove
Cassette
holder
assembly (2)
Worm wheel (3)
Claw
(4)
Lock lever (4)
Boss (2)
Groove (A)
Groove (B)