Tool Use And Care; Air Source - Central Pneumatic 68057 Owner's Manual

Tool Use and care

a. Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against the body
is unstable and can lead to loss of control.
b. Do not force the tool. Use the correct tool for the
application. The correct tool will do the job better
and safer at the rate for which the tool is designed.
c. Do not use the tool if the trigger does not
turn the tool on or off. Any tool that cannot
be controlled with the trigger is dangerous
and must not be used until repaired.
d. Disconnect the tool from the air source
before making adjustments, doing tool
maintenance, clearing jams, touching the
safety nosepiece, leaving work area, loading,
or unloading the tool. Such precautionary
measures reduce the risk of injury to persons.
e. Store the tool when it is idle out of reach
of children and other untrained persons.
A tool is dangerous in the hands of untrained users.
Service
a. Tool service must be performed only
by qualified repair personnel.
b. When servicing a tool, use only identical
replacement parts. Use only authorized parts.

Air Source

a. Never connect to an air source that
is capable of exceeding 200 pSI.
Over pressurizing the tool may cause
bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry, regulated
compressed air at the rated pressure or within the
rated pressure range as marked on the tool. Always
verify prior to using the tool that the air source has
been adjusted to the rated air pressure or within the
rated air-pressure range.
Page 4
SAVE THESE INSTRUcTIONS.
For technical questions, please call 1-800-444-3353.
f. Maintain the tool with care.
A properly maintained tool reduces the
risk of binding and is easier to control.
g. check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that affects the tool's operation. If damaged, have
the tool serviced before using. Many accidents
are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
h. Use only accessories that are identified by the
manufacturer for the specific tool model. Use of
an accessory not intended for use with the specific
tool model, increases the risk of injury to persons.
i. Use only those fasteners listed in the
Specifications chart of this manual.
Fasteners not identified for use with this tool by the
tool manufacturer are able to result in a risk of injury
to persons or tool damage when used in this tool.
c. Use only the lubricants supplied with the
tool or specified by the manufacturer.
b. Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source
for the tool. Such gases are capable of
explosion and serious injury to persons.
Item 68057