Central Pneumatic 68057 Owner's Manual page 14

General Operating Instructions
1. Before each use, test the tool as
directed in the prior section.
2. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
3. Attach the Nailer/Stapler to the air supply at the Air
Inlet Plug. Start your compressor and check the
pressure, making sure it is set not to exceed
120 PSI.
WARNING! TO pREVENT
SERIOUS INJURy: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in
an unexpected direction.
cAUTION! TO pREVENT INJURy: Do not hold tool
near body while firing. Tool recoil can cause injury.
4. To fire, place the nose of the Nailer/Stapler on the
workpiece. The Nailer/Stapler should not fire if the
Safety is not depressed. Once depressed, gently
and briefly squeeze the Trigger once. Do
not fire repeatedly; nails or staples could
bounce off of one another, damaging the
work piece or causing personal injury.
Page 14 For technical questions, please call 1-800-444-3353.
5. To change the depth setting of the Nailer/
Stapler, turn the Adjusting Knob (33) to
the desired setting (note the direction
arrows indicated above the Trigger).
6. If, at the maximum depth setting, the tool requires
more force to accomplish the task, verify that the tool
receives sufficient, unobstructed airflow (CFM) and
increase the pressure (PSI) output of the regulator
up to the maximum air pressure rating of this tool.
cAUTION! TO pREVENT INJURy
FROM TOOL FAILURE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
7. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the trigger again.
e. clean external surfaces with clean, dry cloth.
f. Store indoors out of children's reach.
Item 68057