Installing Cd Cover - Panasonic RX-DT30 Service Manual

R X - D T 3 0 1
Ref. No. 1
Removal of the Servo P.C.B.
15
~~~ I
Procedure
21,31,7
*15 ,
;
Traverse Unit -
Terminals of traverse motor
1. ( 0 - 0 ).
Remove 3 screws
2. Desolder 2 termrnals of spindle motor.
3. Desolder 2 termrnals of traverse motor.
4. Remove the flexrble cable from CN701
Ref. No. '
1 Removal
16
P r o c e d u r e 1
21)31)7 '
*151,16 :
~~,
1. Widen 2 bosses by using a flat tip screwdriver and remove 2 pins.
2. Remove the Traverse Deck Ass'y in direction of arrow @follow by ;2,.
1.
Install the CD open spring as shown in above diagram.
Terminals of spindle motor
of the Traverse Deck Ass'y
CD Open Spring
Removal of the flexrble cable
Push the top of the connector in the
direction of the arrow@, and then
pull out the flexrble cable in the
directron of the arrowa.
P
:
Note
Insert a short pin into the flexible cable for
traverse unit.
2. Install the CD cover onto the top cabinet.
:
Note When installing the CD cover, make sure the CD cover
in half open positron.
IS
Release the spring in the directton of arrow 0.
3.
-8-
Traverse Deck Ass'y