Mecha Aging - Sony DVP-CX850D Service Manual

- Reset SLED TILT
Reset the Sled and Tilt to initial position.
1 LD
Turn ON/OFF the laser.
2 SP Turn ON/OFF the spindle.
3 Focus
Search the focus and turn on the focus.
4 TRK
Turn ON/OFF the tracking servo.
5 Sled
Turn ON/OFF the sled servo.
6 CLVA
Turn ON/OFF normal servo of spindle
servo.
7 FCS. Srch
Apply same voltage as that of focus
search to the focus drive to check the
focus drive system.
Sled FWD Move the sled outward. Perform this
operation with the tracking servo turned
off.
Sled REV Move the sled inward. Perform this
operation with the tracking servo turned
off.
Tilt UP Move the tilt upward.
Tilt DOWN Move the tilt downward.
The following menus are normally not used.
3. Track/Layer Jump
4. Manual Adjustment
5. Auto Adjustment
The persons who do not know well about these menus should not
use them.
6. Memory Check
EEPROM Data
CD --DVD--
ID No.00 SACD SL L0 L1
Focus Gain xx xx xx xx xx
TRK. Gain xx xx xx xx xx
Focus Offset xx xx xx xx xx
TRK. Offset xx xx xx xx xx
L.F. Offset xx xx xx xx xx
EQ. Boost xx xx xx xx xx
Jitter xx xx xx xx xx
Mirror Time xx xx xx
_
CLEAR: Default Set
This screen displays current servo adjusted data stored in the
EEPROM. Though adjusted data can be initialized with the CLEAR
key, they cannot be restored after initialization.
So, before clearing, make a note of the adjusted data.
For reference, the drive has been designed so that the gain center
value is 20 and offset value is 80. Other values will be in a range of
10 to 80. If extreme value such as 00 or FF is set, adjustment will be
faulty. In such a case, check for disc scratch or cable disconnection,
then perform adjustment again.
## 200CHG MechaCon Menu1 ##
ENTER : Table initial
PLAY : Disc1 Move (Chuck)
STOP : UnChuck disc1 Door
PAUSE : SPDL On/Off
<- -> : Chucking Stop
UP : Chucking
DOWN : UnChucking (Full)
jogFOR: Chucking
jogPRV: UnChucking (Step)
_
RETURN: Exit
## 200CHG MechaCon Menu2 ##
ENTER : Table initial
PLAY : Table Move Chuck
STOP : UnChuck disc1 Door
PAUSE : Table Turn R/S/L/S
jogFWD: Table Turn (R Step)
jogPRV: Table Turn (L Step)
DIAL R: NextDisc Chuck
DIAL L: NextDisc Door
UPDOWN: Chuck/UnChuck(Full)
CLEAR : Sensor Check
_
RETURN: Exit

6-6. MECHA AGING

### Mecha Aging ###
Input 5Discs No (1-200)
Disc 1:_
Selecting item 3 from the Test Mode menu implements the
mechanical aging.
Prepare five discs. Input the location number of the five discs
respectively, then press the ENTER key.
### Mecha Aging ###
Input 5Discs No (1-200)
Disc 1:x
Disc 2:x
Disc 3:x
Disc 4:x
Disc 5:x
Press ENTER : OK
Press Other Key : One More
_
After the above message appears, press the ENTER key again.
The following display appears.
6-9
(Full)
(Step)