Design Mode - Toshiba 28Z33B Service Manual

1. ENTERING TO DESIGN MODE
1) Select the Service mode.
S
When QA02 is initialized, items "OPT0", "OPT1" and "OPT2" of DESIGN MODE are set to the data of the representative
model of this chassis family.
Therefore, because ON-SCREEN specification remains in the state of the representative of model. This model is required to
reset the data of items "OPT0", "OPT1" and "OPT2".
2. SELECTING THE ADJUSTING ITEMS
Every pressing of CHANNEL t button in the design mode changes the adjustment items in the order of table-3.
(s button for reverse order)
Refer to table-3 for data of design mode.
(See SETTING & ADJUSTING DATA on page 15)
3. ADJUSTING THE DATA
Pressing of VOLUME s or t button will change the value of data.

DESIGN MODE

2) While pressing o or CALL button on
Remote and press MENU button on TV.
(Design mode)
– 11 –
3) Press MENU button on TV.
Press
D
Press
(Adjustment mode)
ITEM
DATA