V. Size Adjustment (VSIZ)
1. Input a crosshatch signal.
2. Set to Service Adjustment Mode.
3. Select the VSIZ item with
4. Adjust value of VPOS with
center.
5. Press
then
V. Center Adjustment (VPOS)
1. Input a crosshatch signal.
2. Set to Service Adjustment Mode.
3. Select the VPOS item with
4. Adjust value of VPOS with
center.
5. Press
then
H. Center Adjustment (HPOS)
Perform this adjustment after checking H. Frequency.
1. Input a crosshatch signal.
2. Set to Service Adjustment Mode.
3. Select the HPOS item with
4. Adjust the value of HPOS with
horizontal center.
5. Press
then
and
.
and
for the best vertical
to save into the memory.
and
.
and
for the best vertical
to save into the memory.
and
.
and
for the best
to save into the memory.
— 23 —
KV-13M42/13M52/13M53/14MB42/14MB42C
V. Linearity (VLIN), V Correction
1. Input a crosshatch signal.
2. V. correction is automatically adjusted from the circuit
and should satisfy the conditions below.
V LINEARITY (VLIN)
V CORRECTION
Service Adjustment Mode Memory
1. Change the value of the DCOL item to 1.
2. After completing all adjustments, press
Read From Memory
SERVICE
READ
then
.
Green
0
Red
ENTER