T8001F, T8024F FLUSH MOUNT PROGRAMMABLE THERMOSTAT
OPERATION
Setting FAN and SYSTEM Switches
Fan and system settings are controlled manually by
using the switches located at the bottom of the
thermostat case. See Fig. 11.
FAN Switch
Fan switch settings are:
On: The fan runs continuously. Use for improved air
circulation and air quality.
Auto: Normal setting for most homes. In cooling, the
fan starts and stops with the cooling equipment. In
heating, the fan is controlled directly by the heating
equipment and may start a few minutes after the
heating equipment turns on (most systems). When
the fan operation (fuel) switch is in the E position,
the fan starts and stops with the heating equip-
ment.
Slide the FAN switch in the lower left corner of the
thermostat to select the desired fan setting.
SYSTEM Switch
System switch settings control thermostat operation as
follows:
Cool: The thermostat controls the cooling system.
Off: Both heating and cooling are off.
Heat: The thermostat controls the heating system.
Slide the SYSTEM switch in the lower right corner of the
thermostat to select the desired system setting.
Fig. 11. Digital Display and System switches.
69-1465—3
Setting Current Time and Day
1. To Set Current Time.
a. Press Select twice.
b. Press
2. To Set Day of Week.
a. Press Select again.
b. Press
To use the preprogrammed time and temperature (see
Table 3) press Hold to exit the programming mode.
Setting Time and Temperature
The T8001F and T8024F are preprogrammed with the
time and temperature settings shown in Table 3. For
instructions on programming the thermostat, refer to the
Owner's Guide, form no. 69-1464.
Period
Wake
M18612
Leave
Return
Sleep
6
or
to set current time.
or
to set current day.
Table 3. Preprogrammed Time and
Temperature Settings.
Time
Heat Setpoint
6:00 AM
70°F (21°C)
8:00 AM
62°F (17°C)
6:00 PM
70°F (21°C)
10:00 PM
62°F (17°C)
SET
PM
M12591A
SET
PM
M12592A
M12593A
M12594A
Cool Setpoint
78°F (26°C)
85°F (29°C)
78°F (26°C)
82°F (28°C)