Table of Contents
Advertisement
6.
Gently pry up the palmrest and lift it up to remove it from the computer.
Installing the Palmrest
1.
Insert the palmrest into the chassis until it clicks in place.
2.
Connect the touchpad and power connectors to the system board.
3.
Tighten the screws to secure it to the system board.
4.
Turn the computer over and press at the edges to lock into the retaining tabs.
5.
Tighten the screws at the base of the computer.
6.
Install:
a. keyboard
b. memory module
c. hard-disk drive
d. WLAN card
e. access panel
f. optical-disk drive
g. battery
7.
Follow the procedures in After Working Inside Your Computer.
19
Advertisement
Table of Contents
