Shutting Down The Projector; Troubleshooting Your Setup; Status Indicator Light - InFocus IN114ST User Manual

Shutting down the projector

Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the
projector off after no active sources are detected and no user interaction with the
projector is performed for 30 minutes. By default, this feature is off. You can
change the length of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off and the Power LED blinks blue for 1 minute while the fans continue to run
to cool the lamp. If the Power Saving Mode feature is on and when the lamp has
cooled, the LED lights blue and the fans stop. If the Power Saving Mode feature is
off and when the lamp has cooled, the LED blinks blue and the fans stop. Unplug
the power cable to completely power off the projector.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section. If it does not,
troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector
and can help you troubleshoot
Table 4: Status indicator light behavior and meaning

Status Indicator Light

POWER: Solid blue
POWER: Blinking blue
POWER: Blinking blue
TEMP/LAMP: Blinking pink
POWER: Solid blue
TEMP/LAMP: Blinking pink
POWER: Solid blue
TEMP/LAMP: Blinking red
POWER: Solid blue
TEMP/LAMP: Blinking blue
11
.
POWER
TEMP/LAMP
Meaning
1. If the Power Saving Mode feature is on,
the projector is plugged in.
2. The projector is on and initialized.
3. The projector is in normal operation.
1. If the Power Saving Mode is off, the
projector is plugged in.
2. The projector is powering down and the
fans are cooling the projector.
The projector fan(s) are not operating
correctly and the projector has been shut
down.
The lamp failed to ignite.
Contact Technical Support if the problem
persists. Visit www.infocus.com/support to
contact service.
The lamp has reached its end of life and
must be replaced. The lamp will continue
to operate untils it fails.
Contact Technical Support. Repair may be
needed.
1. The projector is overheating and the
lamp will be shut off. The fans will
continue to run.
2. The projector will not turn back on until
the cooling process is complete.