Table of Contents
Advertisement
11.TRANSPORTING THE TRACTOR AND IMPLEMENT
Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind
when you finish working in an area. Therefore, the operator must employ good judgement and safe operation
practices when transporting the tractor and implement between locations. By using good judgement and
following safe transport procedures, the possibility of accidents while moving between locations can be
substantially minimized. OPS-U- 0017
Never allow children or other persons to ride on the Tractor or Implement.
Falling off can result in serious injury or death.
Before transporting tractor between locations, idle
the tractor engine, disengage the attached head,
and wait for all head motion to come to a complete
stop.
Place the boom in its storage cradle rest
support and then turn the joystick master switch to
the OFF position.
•
Placing Boom Articulating Arm on Boom Arm
Rest
•
Extend the dipper section approximately half
way out.
•
Bring the Lift to its full height and carefully
swing the boom back until it is just positioned
over the Boom Rest. NOTE: There is a formed
"V" plate on the dipper section that fits onto the
boom arm rest.
•
Lower the Lift until this "V" rest on the Boom
Rest (this may take come re-adjustment of the
dipper section).
•
Place the Master Switch in to the OFF position.
The boom is now in the transport position. To
remove the boom from the Boom Rest, pull the Lift
back and raise the boom about 6 inches. Then
Swing the boom around to the desired position.
OPS-B- 0013_A
MACHETE BOOM 3/09
©2009 Alamo Group Inc.
OPERATION
Operation Section 3-43
(SG-10)
Advertisement
Table of Contents
