Circuit Boards Location; Schematic Diagram - Sony Trinitron KV-TG21M61 Service Manual

5-2. CIRCUIT BOARDS LOCATION

A BOARD
KV-TG21M61/TG21M90
CV BOARD
V2 BOARD
(KV-TG21M61 only)
F BOARD
A3 BOARD
– 27 –
KV-TG21M61/TG21M90
RM-952 RM-952

5-3. SCHEMATIC DIAGRAM

Note:
• All capacitors are in µF unless otherwise noted.
• All electrolytic capacitors are rated at 50V unless otherwise
noted.
• All resistors are in ohms.
kΩ = 1000Ω, MΩ = 1000kΩ
• Indication of resistance which does not have rating electrical
power is as follows.
Pitch: 5 mm
Rating electrical power 1/4W (CHIP: 1/10W)
• : nonflammable resistor.
• ¢ : internal component.
• : panel designation or adjustment for rrepair.
• All variable and adjustable resistors have characteristic curve
B unless otherwise noted.
• Redings are taken with a color-bar signal input.
no mark : COMMON
( ) : PAL
[ ] : NTSC 3.58
• Readings are taken with a 10 MΩ digital multimeter.
• Voltage are dc with respect to ground unless otherwise
noted.
• Voltage variations may be noted due to normal produc-
tion tolerances.
• All voltage are in Volt.
✽
• : Cannot be measured.
• Circled numbers are waveform references.
• : B +bus.
• : B –bus.
÷
• : signal path.
Reference information
RESISTOR : RN
: RC
: FPRD
: FUSE
: RS
: RB
: RW
: ✽
COIL : LF-8L
CAPACITOR : TA
: PS
: PP
: PT
: MPS
: MPP
: ALB
: ALT
: ALR
Note: The component identified by shading and
mark ! are critical for safety. Replace only
with part number specified.
METAL FILM
SOLID
NONFLAMMABLE CARBON
NONFLAMMABLE FUSIBLE
NONFLAMMABLE METAL OXIDE
NONFLAMMABLE CEMENT
NONFLAMMABLE WIREWOUND
ADJUSTMENT RESISTOR
MICRO INDUCTOR
TANTALUM
STYROL
POLYPROPYLENE
MYLAR
METALIZED POLYESTER
METALIZED POLYPROPYLENE
BIPOLAR
HIGH TEMPERATURE
HIGH RIPPLE
– 28 –