Page 5
WARNING Table of contents • Dangerously high voltages are present inside the TV. Getting Started • Operate the TV only at 110-240 V AC. • Do not open the cabinet and the rear cover of the TV. 6 Connections Refer servicing to qualified personnel. 8 Presetting channels •...
Page 6
Getting Started Connections Connecting a VHF antenna or a combination VHF/UHF antenna — 75-ohm coaxial cable (round) Attach an optional IEC antenna connector to the 75-ohm coaxial cable. Plug the connector into the (antenna) socket at the rear of the TV. Rear of TV Rear of TV On a wall...
Page 7
Connecting optional equipment You can connect optional audio/video equipment to your TV such as a VCR, multi disc player, camcorder, video game, or stereo system. Connecting video equipment using video input jacks Front of TV Camcorder L ( MONO ) to video and audio outputs to …...
Page 8
If the picture color is poor and/or the Presetting channels sound is noisy Select the appropriate TV system as follows: Press SELECT on the remote commander or the TV until TV SYSTEM appears. Press +/– on the remote commander or .+/– on the TV until the picture and sound become normal.
Page 9
To start presetting channels automatically Press +/– on the remote commander or Á +/ from the specified program position – on the TV until the required channel Press PROGR +/– or number buttons on the remote picture appears on the screen. commander or PROGR +/–...
Page 10
Operations Watching the TV Turning off the TV To turn off the TV temporarily Press u on the remote commander. The u indicator lights up. Press U to turn on the TV. To turn off the TV completely Press U on the TV. If the power on the TV is turned off in standby mode, the u indicator may remain alight for a while.
Page 12
Each time you press SELECT, the screen changes as Adjusting the follows: picture PICTURE COLOR BRIGHT (Operative for NTSC signal only) BALANCE ÷ SOUND MODE +/– SELECT TREBLE BASS SHARPNESS PIC MODE Press +/– to adjust the item. Selecting the picture mode Press PIC MODE until the mode you want appears.
Page 13
If the sound is distorted or noisy When receiving programs through the (antenna) terminal: Change the “TV SYSTEM“ setting level in the on- screen display until the sound becomes clear. Selecting the sound mode Press SOUND MODE until the mode you want appears.
Page 14
Additional Information No picture Troubleshooting No sound / Press U. / Check the antenna connection. / Check the VCR connections. / Check the power cord connection. If you have any problems, read this manual again and / Check the standby mode. check the countermeasure for each of the symptoms listed below.
Page 15
(Video): 1 Vp-p, 75 ohms (Audio): 500 mVrms 22 in. Picture tube Tube size (cm) Screen size (cm) 516 × 464 × 478 Dimensions (w/h/d, mm) Mass (kg) Design and specifications are subject to change without notice. Sony Corporation Tokyo, Japan...