Philips HomeRun FC9910 User Manual page 31

Problem
The robot does
not charge.
The robot does
not return to the
base station after
cleaning.
Cause
The remote control is too
close to the base station.
The base station or robot
is not properly connected
to the mains.
You started cleaning in
AUTO cleaning mode from
another place in the room
than the base station.
The base station or robot
is not properly connected
to the mains.
The infrared signal
generator or emitter on
the base station or one or
more sensors on the robot
are covered.
The base station is located
behind a wall or other
obstacle that blocks its
signal.
You cleaned a small area in
sPOT cleaning mode.
solution
Move further away and then operate the remote
control again while pointing it in the direction of
the base station.
Make sure you insert the small plug into the
socket on the base station or robot properly. Also
make sure that you insert the small plug of the
mains cord into the adapter properly and that
you insert the mains plug into the wall socket
properly.
if you start the robot from another place in the
room, it returns to the place where it started
cleaning.
Make sure you insert the small plug into the
socket on the base station or robot properly. Also
make sure that you insert the small plug of the
mains cord into the adapter properly and that
you insert the mains plug into the wall socket
properly.
Remove the object that covers the infrared signal
generator or emitter or the object that covers
one or more sensors of the robot.
Put the base station in a different place. Make
sure that there are no obstacles within 0.5m on
both sides of the base station.
When the robot has cleaned the area, it
automatically stops. You can press the BASE
button on the remote control to make the robot
return to the base station or you can press the
MODE button to switch to AUTO cleaning
mode. In AUTO cleaning mode, the robot returns
to the base station automatically.
31