To Connect Demos On The Terminal To The Image View - Honeywell Dolphin Demos User Manual

To Connect Demos on the Terminal to the Image View

The following Demos contain a Port Config feature that enables you to connect with Image View on the
workstation:
Imaging Demo
IQ Imaging Demo
Scan Demo
Signature Capture
A window opens that enables you to configure the radio connection to Image View on the workstation.
Enter the same IP Address and TCP Port that was entered in Image View on the host workstation. These
values must match!
When you tap Close, you are prompted to save settings. Tap Yes. The terminal begins connecting
immediately.
When you save the settings:
1. You will be able to send data from these Demos to Image View on the workstation when the
terminal's radio is enabled; see
2. These settings are saved to a Demo RF Settings.exm file that is stored in the \IPSM folder so the
connection persists through cold boots. Tap Start > Power Tools > EZConfig Utilities > Demo RF
Settings.exm.
Note: When you set up Port Config in one Demo, the settings applies to all the Demos.
8 - 2
Tap Setup > Port Config.
Tap Settings > Port Config.
Tap Setup > Port Config.
Tap File > Port Config.
Send and AutoSend
Rev A
8/6/08
on page 8-3.
Dolphin® Demos User's Guide