Replacing The System Fan Assembly - Lenovo ThinkCentre 4466 Hardware Maintenance Manual

5. Carefully press the other side of the socket cover downwards until the socket cover snaps into place.
Figure 91. Securing the socket cover
6. Carefully check the four corners of the socket cover to make sure that the cover is secured in the
microprocessor socket.
7. Lower the microprocessor retainer and then lower the lever to secure the retainer. Make sure the
lever is locked into position.
8. Follow any additional instructions included with the replacement part you received.

Replacing the system fan assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre User Guide. To obtain a copy of the ThinkCentre User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to replace the system fan assembly.
To replace the system fan assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Open the computer cover. See "Opening the computer cover" on page 121.
3. Remove the hard disk drive. See "Replacing the hard disk drive" on page 134.
4. Locate the system fan assembly. See "Locating components" on page 118.
5. Disconnect the system fan assembly cable from the system fan connector on the system board. See
"Locating parts on the system board" on page 77.
.
Chapter 9 Replacing FRUs (Machine Types: 4466, 4471, 4474, 4477, 4480, 4485, 4496, 4498, 4503, 4512, 4514,
4518, 4554, 7005, 7023, 7033, 7035, 7072, 7079, and 7177.)
153