Lenovo ThinkCentre 4466 Hardware Maintenance Manual page 112

9. To install a new hard disk drive into the blue bracket, flex the bracket and align pin
and pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board 5 on the bottom of the hard disk drive.
Figure 36. Installing the hard disk drive into the bracket
10. Slide the new hard disk drive into the drive cage until it snaps into position.
11. Align the drive cage pivot pin with the slot
cage into the chassis.
12. Connect the signal cable and the power cable to the new hard disk drive.
13. Press down on the metal latch
computer until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard disk drive cage. The
arrows are aligned when the hard disk drive is in the proper position.
Figure 37. Installing the primary hard disk drive
104
ThinkCentre Hardware Maintenance Manual
1 in the upper drive cage and slide the hard disk drive
2 and pivot the drive cage into place, and then slide it to the front of the
1 , pin 2 , pin 3 ,