SINGLE CONTROL KITCHEN
FAUCET WITH CAST SPOUT
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
TOOLS REQUIRED
Channel Locks
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
CAUTION
Turn off hot and cold water supplies before beginning.
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON (1).
TUBES (3) and SHANK (4) through hole of ESCUTCHEON (1) and mounting surface. Make certain the O-RING (2)
is properly seated in recess of SPOUT BASE. Follow mounting instructions below to secure faucet to mounting surface.
(B)
Installation less ESCUTCHEON (1). Remove ESCUTCHEON (1) , feed FAUCET TUBES (3) and SHANK (4) through
DECORATIVE FLANGE (10). Push FLANGE so the raised step fits into recess of SPOUT BASE.
Push O-RINGS (2) onto SPOUT SHANK. Make certain the O-RING (2) is properly seated in recess of DECORATIVE
FLANGE (10).
Insert SUPPLY TUBES (3) and SHANK (4) through mounting hole and seat DECORATIVE FLANGE (10) onto sink or
mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7) onto SHANK (4) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening
the screws slightly each time until all are snug to ensure even pressure.
8
S P O U T B A S E
2
1
P U T T Y
Installation
Phillips Screwdriver
Regular Screwdriver
A
4
3
5
6
7
9
Instructions
3821.631 SERIES
3821.641 SERIES
3821.634 SERIES
3821.644 SERIES
Adjustable Wrench
8
S P O U T B A S E
2
S I N K O R
M O U N T I N G
S U R F A C E
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
Insert supply
B
10
4
3
5
6
7
9
M 9 6 8 1 8 8 E
Tubing Cutter