Plasma Display Panel Unit Removal (1/2) - Sony PFM-42B1 Service Manual

2-2-10. Plasma Display Panel Unit Removal (1/2)

* Remove the Bezel assy. (Refer to 2-2-3.)
* Remove the B block assy. (Refer to 2-2-4.)
* Remove the Power supply assy. (Refer to 2-2-7.)
* Remove the T board. (Refer to 2-2-9.)
Remove those parts according to
1 through @/ 1 1 @/ @/. @/
numbers 1 1 @/
5 Screw
(+PSW4 x 8)
6 Corner bracket (A)
!, Three screws
(+PSW4 x 16)
!. Three S boards
@/ Three S board brackets
Wire (for reference)
Note) If two wires attached on the glass surface of
plasma display panel, be careful not to cut them.
PFM-42B1, PFM-42B1E
0 Screw
(+PSW4 x 8)
9 Two screws
(+PSW5 x 40)
!- Corner bracket (B)
4 Two screws
(+PSW5 x 40)
!\ Screw
(+PSW3 x 16)
!; S board
!' S board bracket
7 Two screws
(+BVTP4 x 16)
8 Inlet bracket
2 Screw
(+PSW4 x 8)
1 Two screws
(+PSW5 x 40)
CN1
!= Two screws
(+PSW5 x 40)
![ Screw
(+PSW4 x 8)
!] Corner bracket (A)
3 Corner bracket (B)
Cushion
2-11