Motor Synchronous And Valve Replacement; Brake Adjustment - Daewoo DWF-760 Service Manual

Motor Synchronous And Valve Replacement(Non Pump Model)
Lay the front of the floor.
Loosen two special screw and motor synchronous.
Turn the valve by using screw driver as shown in
picture.

Brake Adjustment

Loosen the adjustment bolt and turn the adjust-
ment bolt until the end of the bolt touches to the
brake lever.
Tighten the lock nut and apply a small amount of
paint-lock.
Adjustment bolt
Clutch lever
Gear mechanism ass'y
Take out the wire of motor synchonous from the
bracket.
Separate the motor sycnchronous from the base.
Remove the valve lid from the valve drain assy.
NOTES:
1. The brake adjustment has been made at the
factory, so that it is not re-adjust.
However, in case of insufficient brake operation,
problem the upper procedure.
2. Overtightening of the adjustment bolt will cause
poor brake performance.
Brake lever
3. Undertightening of the adjustment bolt will
cause continuous braking and thereby.
cause the problems of the motor during the
spingcycle.
DIRECTIONS 17