Before Installation; Where To Install; Feed Water Pipe Installation (Dispenser Model Only) - LG MFL67683081 Owner's Manual

Select a good
location
Disposal of the
old appliance
Before
installation
Warning
Precautions when
using the dispen-
ser (on some
model)

Where to install

1. Place your appliance where it is easy to use.
2. Avoid placing the unit near heat sources, di-
rect sunlight or moisture. Do not operate the
appliance outdoors where it can be exposed
directly, or indirectly to sun, wind and rain.
3. To ensure proper air circulation around the
space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.
4. To avoid vibrations, the appliance must be
levelled.
5. Do not install the appliance in temperatures
of less than 5°C as the performance may be
als which are reusable and/or recyclable.
All the packaging materials should be sent to the collection centre for recycling. For
details of your local recycling centre, please contact your local council.

Feed water pipe installation (Dispenser model only)

Automatic ice maker operation needs water pressure of 147~834kPa
(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is
If water pressure does not reach the rating 147kPa(1.5kgf/cm
is necessary to purchase a separate pressure pump for normal automatic icing
and cool water feed.
Keep the total length of the feed water pipe tube within 8m and be careful that
the tube does not bend. If the tube is 8m or longer it may cause water feed prob-
lems owing to the drain water pressure.
Install the feed water pipe tube at a place free from heat.
To get cold water
The dispensed water will not be icy cold, but just cool or cold. If you want colder
water, dispense ice before dispensing water.
Rotate the rotary gear in 1/4 cycle as shown in the illustration and then push it back.
NOTE
• Figure
Installation
-
) or below, it
2