Adj Products, Llc - Www.adj.com - Ultra Hex Par3 User Manual - ADJ ULTRA HEX PAR3 User Instructions

Ultra Hex Par3
button until "don" is displayed, press the UP button to display "doff".
Now the display will disappear after 20s. Press any button to turn the
display on again. Be advised though that the display will turn off auto-
matically after 20 seconds.
To set the display press the MODE button until "dXX" is displayed.
Use the UP or DOWN buttons to select either:
"don" = LED display on at all times.
"doFF" = LED display shuts off after 20 seconds.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "rFXX" is displayed. "XX" repre-
sents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display
can be read upside down.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until either "Stnd" or "rEv" is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Default Running Mode:
This is a default running mode. When this mode is activated all modes
will return to their default settings.
1. Plug the fixture in and press the MODE button until "dXX" is dis-
played. "XX" represents either "on" or "oFF".
2. Press the SET UP button until "dEFA" is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the
MODE button to exit.
ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 10
Operating Instructions Ultra Hex Par3
Dimmer Curve:
This is used to set the dimmer curve used with DMX mode.
1. Plug the fixture in and press the MODE button until the DMX
address is displayed.
2. Press the SET UP button until "dr-X" is displayed. This is the dim-
mer setting. "X" represents the dimming mode.
3. Use the UP and DOWN buttons to find your desired dimmer
curve. Press SET UP when you are finished.
DMX State:
This mode can be used as a precaution mode, that in case the DMX
signal is lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You can also
set this as the operating mode you would like the unit to return to when
power is applied.
1. Press the MODE button until the DMX address is displayed. Press
the SET UP button until "No-X" is displayed.
2. "X" represents a number between 0-2. Choose an operating mode
you would like the unit to start up in when the DMX signal is lost
or interrupted.
• "No-0" (Blackout) - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
• "No-1" (Last State) - If the DMX signal is lost or interrupted, the fixture
will stay in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
• "No-2" (Auto Run) - If the DMX signal is lost or interrupted, the unit will
automatically go into Auto Run mode.
3. Press SET UP to confirm your desired set up.
ADJ Products, LLC - www.adj.com - Ultra Hex Par3 User Manual Page 11
Operating Instructions