ESSID
Channel Number
Associated Clients
Root AP SSID
Site Survey
(maximum transfer rate 11Mbps).
2.4 GHz (B+G+N): 2.4GHz Band, Allows
802.11b, 802.11g, and 802.11N wireless
clients. It's recommends to select this band to
maximize compatibility.
This is the name of broadband router. You can
type any alphanumerical characters here,
maximum 32 characters. ESSID is used to
identify your own broadband router from
others when there are other broadband
routers in the same area. Default SSID is
'default', it's recommended to change default
ESSID value to the one which is meaningful to
you, like myhome, office_room1, etc.
Select the channel number you wish to use; all
access points must use the same channel.
Click 'Show Active Clients' button to show
the list of all connected wireless clients. You
can click 'Refresh' in new window to get
latest list again, or click 'Close' to close the
window.
Please note that if you have pop‐up blocker
installed, you may have to disable it or tell
your pop‐up blocker to allow the popup
window, or you will not be able to see the
wireless client list window.
Please input the SSID of the wireless access
point you wish to extend signal coverage.
Click 'Select Site Survey' and a popup window
will appear. All reachable wireless access
points will be shown in the window. Select the
wireless access point you wish to connect from
the list, and click 'Done'. If the wireless access
point you wish to connect is not listed, you can
click 'Refresh' to rescan.
If you still can't find the wireless access point
you wish to connect, please move the
broadband router to the place nearer to the
access point you wish to connect.