Table of Contents
Advertisement
3. Connect the power adapter to the wall socket, and then connect it to the '5VDC' socket
of the router.
4. Please check all LEDs on the front panel. 'PWR' LED should be steadily on, WAN and LAN
LEDs should be on if the computer / network device connected to the respective port of
the router is powered on and correctly connected. If PWD LED is not on, or any LED you
expected is not on, please recheck the cabling, or jump to '4‐2 Troubleshooting' for
possible reasons and solution.
5. To improve wireless signal reception, please arrange the antenna and make it
perpendicular to the ground, and place the wireless access point in open space. Please
keep the distance between antennas, if the antennas are too close to each other,
wireless signal reception will be affected.
Advertisement
Table of Contents
