Edimax BR-622nC User Manual page 103

Remote Port Range
Traffic Type
Protocol
Add
Reset
Edit
Delete Selected
Delete All
Move Up
Move Down
When you finished with the settings in this page, you can click 'Apply' button to save
changes you made in this page, or you can click 'Cancel' to discard changes. After you click
'Apply' button, you'll see the following messages:
the IP address in left field only.
Set the port range that will activate this QoS
rule. If only one port is involved, input a single
number here (1 to 65535); if multiple ports are
involved, input starting / ending port number in
x‐y format (like 10‐20).
If you're creating a QoS rule for a specific type
of traffic, you can select it from this menu and
you don't have to input port range above.
Select the protocol type here (TCP or UDP).
Click 'add' button to add a new QoS rule
(detailed instructions will be given below).
If you want to erase all values you just entered.
Click 'Reset'
If you want to modify the content of a specific
rule, please check the 'select' box of the rule you
want to edit, then click 'Edit' button. Only one
rule should be selected a time!
You can delete selected rules by clicking this
button. You can select one or more rules to
delete by check the 'select' the box of the rule(s)
you want to delete a time. If the QoS table is
empty, this button will be grayed out and
cannot be clicked.
By clicking this button, you can delete all rules
currently listed in the QoS table. If the QoS table
is empty, this button will be grayed out and
cannot be clicked.
Move selected rule up. First QoS rule will be
proceed first, so you can move higher priority
rules up.
Move selected rule down.