Commissioning; Automated Mode; Manual With Normal Control; Manual With Irt9090 - Philips OccuSwitch DALI LRM2070 Datasheet

LRM2070, LRM2080, LRM2090 Datasheet
OccuSwitch DALI sensor/controller

Commissioning

Desired standard light level
There are three ways to set the light level.

Automated mode

Step 1 Press the OccuSwitch DALI button
for 3 seconds until the LEDs start a
yellow/green sequence
Step 2 Release and press again, the LEDs will
now blink red/green
Step 3 Clear the area beneath the
OccuSwitch DALI
Step 4 Within 10 seconds the auto
calibration starts
Lights will switch off and on to
determine the installed lux level
Lights will flash to indicate a successful
operation
The calibration is finished.
Delay time occupancy control
With the rotary dial it is possible to select a time delay of 70s, or 5 to
30 minutes (in 5 minute increments).
Further commissioning
Using IRT9090
The OccuSwitch DALI will acknowledge commissioning commands by
flashing the lights.
The IRT9090 extended IR programming tool has a narrow beam to
prevent that neigboring OccuSwitch DALI units are programmed by
mistake. You must be within 17 meters of the device and aim exactly
at it.
IRT9090 Send command
commissioning tool

Manual with normal control

Step 1 Use a remote or switch to set the
desired light level
Step 2 Press the OccuSwitch DALI button
until the LEDs start a yellow/green
sequence
Step 3 Clear the area beneath the
OccuSwitch DALI
Step 4 The light level existing 10 seconds
after step 2 is used as set point
Lights will flash to indicate a successful
operation
The calibration is finished.
Max. 17m
= 1x

Manual with IRT9090

Step 1 Use the up and down keys to create
Step 2 Press the "SAVE" button
Step 3 The lights will flash once to indicate
Rotary
Luxmeter
Calibrate light level
the desired light level
calibration was successful.
9/15