Initial Set Up Guide - Bunn Home Brewer Use And Care Manual

Initial Set Up Guide

IMPORTANT:
Brewer is NOT ready to plug in until you have followed
the steps below. Do NOT plug in brewer until step #5.
1. Slide empty funnel into funnel guides
as shown.
2. Fill decanter with cold water. Swivel
or lift brewer lid and pour water into
brewer. Position decanter on base
below funnel. Close the lid and wait
three minutes while the internal tank
partially fills.
3. Open the lid. Remove decanter and
fill with cold water again. Pour water
into brewer. Position decanter on base
under funnel and close the lid.
4. Wait until water flows from the funnel.
When water flow stops, pour out
any water that has collected in the
decanter. Replace decanter on brewer
below the funnel.
5. Now, plug in the brewer.
6. Press the bottom of the vacation switch,
located on the side of the brewer, to turn
unit on (Press I to turn on and press O
to turn off.) Wait 15 minutes for the water
in the tank to heat.
See steps on page 5 for brewing perfect coffee.
4
Meijer.com
NHBX BTX/BX/GRX