Table of Contents
Advertisement
3) Lens : Select lens (DC lens/Video lens/Manual Lens)
- Iris Speed: Only for DC/Video Lens, Adjust Iris speed.
NOTE:
* If iris speed is too high, it can occur AE hunting.
* If iris speed is too low, IRIS adjusting operate too slowly.
4) LLC (Line Lock Control)
Active only used AC Power. - Int(Internal)/Ext(External)
If mode is set to Ext, Sync Phase can be adjusted.
5) Day/Night
- Detection: Configuration D/N change method. (Internal/Fix-Day/Fix-Night/EXT-IN)
Internal: Operating DN changing with internal detection algorithm.
Fix-Day: Day mode fixed.
Fix-Night: Night mode fixed.
External: Work with EXT-IN mode. If port input voltage is high,
DN mode is Night. And If port w voltage is low, DN mode is Day.
- Burst: Select burst signal on/off at night mode.
- Delay (sec): Select Delay time in D/N mode changing.
- D/N Threshold: Configuration for threshold level in D/N mode changing.
(Low/Mid/High/User)
NOTE:
* User Mode : Difference of D>N Level and N>D Level must be more than 2,
and D>N must be less than N>D.
D>N: Adjust level that changing point of Day -> Night.
N>D: Adjust level that changing point of Night -> Day.
- OPD: Optical detector value. Represent present physical brightness.
- Use Alt Camset(N), Alt Camset:
Select camera configuration set to apply in night mode.
NOTE:
* Not support in single camset mode.
6) EXT-I/O
- D/N OUT (Day&Night Output) : Select output method, No Func/D/N Out/AUX0
AUX0: User Defined output 0.
Set AUX0: Output voltage through to D/N OUT port (On:5V/Off:0V)
- ALARM OUT: Select output method, No Func/Alarm Out/AUX1
AUX1: User Defined output 1.
Set AUX1: Output voltage through to D/N OUT port (On:5V/Off:0V)
- D/N IN: Select input method. No Func/Alt Camset.
Alt. Camset: When inputted signal, change camera configuration.
Select camset number
7) Counter: Configurations for output of counting machine.
-
,
: Represent counting value / adjust offset value.
- Alarm On Zero: When counter value reached zero, will be alarmed.
Preset Cnt1, Cnt2: When counter reached zero, counter value will be reset this
value.
Reset: Initialize counter. (Default Zero, or Alarm on zero enabled: Offset Value)
TextOut to Comm: Event string sends through RS-485 lines.
NOTE:
* Event Out must be activated.
18
Advertisement
Table of Contents
