Removal - Kanguru 2.5'' User Manual

• No power is saved during this period.
• The RPM speed of HDD motor is at its highest.
• Hard Drive is in normal access mode.
• Mode indicated by the front Green (Kanguru) LED blinking to indicate disk
access.
Idle mode initiates when no data is accessed within 3 seconds of Active mode.
• Disk operates at about 80% of normal power consumption
• The RPM speed of HDD motor is slightly lower than in Active mode.
• The LED labeled "Idle" on the KanguruEco Drive will be blinking.
Standby mode initiates when no data is accessed within 3 minutes of Active
mode.
• Disk operates at about 10-20% of normal power consumption
• The RPM speed of HDD motor is at its lowest possible speed.
• The LED labeled "Standby" on the KanguruEco Drive will be blinking.
Power Down mode initiates when no data is accessed within 5 minutes of Active
mode.
• Disk operates at about 5-10% of normal power consumption
• The HDD motor is not active in this mode.
• The LED labeled "Power Down" on the KanguruEco Drive will be blinking.

Removal

Windows
To properly remove the drive from your computer, click on the green arrow icon
in the lower right hand side of the taskbar. This will allow you to select any
removable devices that you have connected to your computer. Select the drive
that you want to remove and Windows will tell you when it is safe to remove the
device.
Mac OS
To properly remove the drive from your computer, drag the drive icon from your
desktop to the trash bin. This will safely eject the drive from your system. Your
system may freeze up or give you an error message if you disconnect the device
without properly removing it first.
CAUTION!!
Do not unplug the KanguruEco Drive from the USB port of your computer or HUB
while copying files to or from the device or while files or applications stored on
the KanguruEco Drive are in use. DOING SO MAY RESULT IN LOSS OF DATA
OR DEVICE DAMAGE.