Yamaha Motif-Rack XS Owner's Manual page 92

Multi Mode
Mono / Stereo
Output Select
Chorus Send
(Key Chorus Send)
Reverb Send
(Key Reverb Send)
Dry Level
4 MEQ (Master EQ)
From this display you can apply five-band equalization to all parts of the
selected Multi.
Shape
Freq
(Frequency)
92
MOTIF-RACK XS Owner's Manual
Determines the signal configuration for the Audio Input Part, or how the signal or signals are routed
(stereo or mono).
Settings: L mono, R mono, L+R mono, stereo
L mono .................. Only the L channel of the audio input is used.
R mono .................. Only the R channel of the audio input is used.
L+R mono.............. The L and R channels of the audio input are mixed and processed in mono.
stereo .................... Both the L and R channels of the audio input are used.
Determines the specific output(s) for the Audio Input Part signal.
Settings: For details, refer to Output Select List (page 90) of the Supplementary information.
Determines the Send level of the Audio Input Part signal sent to the Chorus effect. The higher the
value, the more pronounced the Chorus. This parameter can be set only when "Output Select" is set
to "L&R."
Settings: 0 – 127
Determines the Send level of the Audio Input Part signal sent to the Reverb effect. The higher the
value, the more pronounced the Reverb. This parameter can be set only when "Output Select" is set
to "L&R."
Settings: 0 – 127
Determines the level of the Audio Input Part which has not been processed with the System Effects
(Reverb, Chorus). This parameter can be set only when "Output Select" is set to "L&R."
Settings: 0 – 127
Enables you to select one of two equalizer shapes: shelving or peaking. This parameter is available
for Low and High.
Settings: shelv (shelving type), peak (peaking type)
shelv
This type of EQ shape lets you attenuate/boost the signal at frequencies above or below the specified Frequency setting.
EQ Low
Gain
+
Frequency
0
–
Frequency
peak
This type of EQ shape lets you attenuate/boost the signal at the specified Frequency setting.
Gain
+
Frequency
0
Frequency
–
Frequencies around this point are attenuated /boosted by the "Gain" setting below.
Settings:
Low
When the Shape is set to "shelv": 32Hz – 2.0kHz
When the Shape is set to "peak": 63Hz – 2.0kHz
Lo-Mid, Mid, Hi-Mid
100 Hz – 10.0 kHz
High
500 Hz – 16.0 kHz
Gain
Q (frequency bandwidth)
+
0
–
Low Lo-Mid Mid
5 bands
EQ High
Gain
+
Frequency
0
–
Frequency
Frequency
Hi-Mid High