Troubleshooting
●
When the Element for which the XA Control parameter is
set to "AF 1 on," "AF 2 on" or "all AF off" on the MOTIF-
RACK XS Editor does not produce any sound, have you
operated the Controller to which the A.Func [1] or [2]
button is assigned?..............................................page 101
System settings (Utility):
●
Have the MIDI receive channels been set correctly?
→
→
[VOICE]
[UTILITY]
....................................................................................................... page 102
●
Is the MIDI IN/OUT setting appropriate?
→
→
[VOICE]
[UTILITY]
........................................................................................................ page 99
External Device or Sequencer settings:
●
When playing this MOTIF-RACK XS using an external
MIDI sequencer, have the transmit channels for each
sequencer track and the receive channels for each Part in
the Multi been set correctly?
→
→
[MULTI]
[EDIT]
select any Part
→
[ENTER]
"Receive Ch" ................................................................ page 94
●
Are the MIDI "echo" settings (MIDI through) set
appropriately?
For details, refer to the manual of your DAW software.
●
When playing back a song data using an external
sequencer or computer, have the volume and expression
parameters been set appropriately?
External audio devices or cables:
●
Has the audio equipment been connected correctly?
.............................................................................. page 13
●
Are any of the MIDI cables damaged?
●
Is the volume of the external device set to an appropriate
level?
Distorted sound
●
Are the effect settings appropriate?
Use of an effect at certain settings may produce distortion.
...........................................................pages 33, 38 and 57
●
Are the filter settings appropriate?
Excessively high filter resonance settings can cause
distortion.
.................................................................pages 76 and 88
●
Is the MASTER VOLUME set so high that clipping is
occurring?................................................pages 65 and 91
Is the volume of each Element in the Voice mode or the
volume of each Part in the Multi mode set too high?
.................................................................pages 65 and 94
Sound is very quiet.
●
Has the MIDI volume or MIDI expression been set too
low?
●
Is the cutoff frequency of the filters set too low?
.................................................................pages 76 and 77
110
MOTIF-RACK XS Owner's Manual
→
→
select "Voice MIDI"
[ENTER]
"Receive Ch
→
→
select "MIDI"
[ENTER]
"MIDI In/Out"
→
→
[ENTER]
select "Voice"
Playback continues without stopping.
●
When the [AUDITION] button is turned on, press it again
so that its lamp turns off.
The pitch is wrong.
●
Is the tune setting appropriate?
→
[UTILITY]
select "General"
●
Is the "Note Shift" setting appropriate?
→
[UTILITY]
select "General"
●
Have the micro tuning parameters been set to an
unconventional scale?
→
[VOICE]
[EDIT]
........................................................................................................ page 66
●
Have the pitch related parameters been set
appropriately? ......................................... pages 74 and 85
●
On the MOTIF-RACK XS Editor, has the Pitch Modulation
→
Depth been set too high?...................................... page 81
●
Have the following parameters been set to values other
than "0"?
→
[MULTI]
[EDIT]
→
[ENTER]
"Note Shift" or "Detune"............................................... page 94
On the MOTIF-RACK XS Editor, turn [Voice] on
→
"Oscillator/Pitch"
→
[UTILITY]
select "General"
Sound is choppy and intermittent.
●
Are you exceeding the maximum polyphony of the
instrument?............................................................ page 52
Only single notes are sounded (no chords).
●
Has the "Mono/Poly" parameter been set to "mono"?
→
[VOICE]
[EDIT]
........................................................................................................ page 65
→
[MULTI]
[EDIT]
→
[ENTER]
"Mono/Poly" .................................................................. page 95
No effects are applied.
●
Have the parameters in the Effect Dialog been set
appropriately? ....................................................... page 34
●
Have any or all of the effect types been set to "thru" or "No
Effect" (in the Effect display of the Voice Common Edit
mode)?
On the MOTIF-RACK XS Editor, have any or all of the
Elements' Effect Output parameters been set to "thru"?
.............................................................................. page 72
●
Has the Insertion Effect Switch for each Part been set to
on?......................................................................... page 97
→
→
[ENTER]
"Tune" ...................... page 98
→
→
[ENTER]
"Note Shift" ............... page 98
→
→
→
select "Play Mode"
[ENTER]
→
→
→
select any Part
[ENTER]
select "Play Mode"
→
select any Element/Key
→
"Coarse" or "Fine" ...................................... page 74
→
→
[ENTER]
"Note Shift" .............. page 98
→
→
→
select "Play Mode"
[ENTER]
→
→
→
select any Part
[ENTER]
select "Play Mode"
Micro Tune No.
→
"Mono/Poly"
→