Yamaha Motif-Rack XS Owner's Manual page 72

Voice Mode
9
Effect
n
This display can be called up by pressing and holding the [EFFECT] button on the front panel.
1 Insertion Connection
2 Chorus Send
3 Chorus To Reverb
4 Chorus Return
5 Chorus Pan
6 Reverb Send
7 Reverb Return
8 Reverb Pan
Element Out 1 – 8
9 Ins A (Insertion Effect A)
) Ins B (Insertion Effect B)
! Chorus
@ Reverb
Effect Parameters
Switch
Category
Type
Preset
Effect Parameter 1 – 16
72
MOTIF-RACK XS Owner's Manual
9 2
1
) 6
From this display you can set the effect routing for Insertion Effects A and B. The setting changes are
shown on the diagram in the display, giving you a clear picture of how the signal is routed. For
details, see page 58.
Settings: parallel, ins A > B, ins B > A
parallel............................... Signals processed with the Insertion Effect A and B block will be sent to the Reverb, Chorus,
Master Effect and Master EQ blocks.
ins A > B............................ Signals processed with Insertion Effect A will be sent to Insertion Effect B and signals
processed with Insertion Effect B are sent to the Reverb, Chorus, Master Effect and Master EQ
blocks.
ins B > A............................ Signals processed with Insertion Effect B will be sent to Insertion Effect A and signals
processed with Insertion Effect A are sent to the Reverb, Chorus, Master Effect and Master EQ
blocks.
Adjusts the chorus send level. The higher the value, the more pronounced the Chorus. This
parameter can be changed directly via the Knob.
Settings: 0 – 127
Determines the Send level of the signal sent from the Chorus Effect to the Reverb Effect. The higher
the value, the deeper the Reverb that is applied to the Chorus-processed signal.
Settings: 0 – 127
Determines the Return level of the Chorus Effect.
Settings: 0 – 127
Determines the pan position of the Chorus effect sound.
Settings: L63 (far left) – C (center) – R63 (far right)
Adjusts the reverb send level. The higher the value, the more pronounced the Reverb. This
parameter can be changed directly via the Knob.
Settings: 0 – 127
Determines the Return level of the Reverb Effect.
Settings: 0 – 127
Determines the pan position of the Reverb effect sound.
Settings: L63 (far left) – C (center) – R63 (far right)
Determines which Insertion Effect (A or B) is used to process each individual Element on the MOTIF-
RACK XS Editor. The "thru" setting lets you bypass the Insertion Effects for the specified element.
Settings: thru (through), insA (insertion A), insB (insertion B)
When the cursor is located here, pressing the [ENTER] button or the Encoder knob calls up the
Effect Parameter display.
This parameter is available only for Master Effect. The value cannot be changed here.
From the Category column, you can select one of the Effect Categories, each of which contains
similar Effect types. From the Type column, you can select one of the Effect Types listed in the
selected Category.
Settings: Details about the Effect categories and the Effect types are described on page 59.
n
The "Category" is not edited in the Reverb effect parameter display because there is only one Reverb category.
This lets you call up pre-programmed settings for each Effect Type, designed to be used for specific
applications and situations.
n
For details about "Preset" settings, refer to the separate Data List booklet.
The effect parameter differs depending on the currently selected effect type. Refer to page 61 for
details about the Effect parameters. Refer to the separate Data List booklet for information on the
parameters for each Effect type.
! 3 4 5
@ 7 8