Freecom NETWORK STORAGE CENTER/NETWORK MEDIA CENTER User Manual page 46

Freecom Network Storage Center / Network Media Center
7.1. Adding and removing mapped network shares
EN
You can assign a drive letter to shared folders on your Network Storage Center / Network
Media Center. This allows you to access files in Windows more quickly.
7
7.1.4 Start recovery procedure
This procedure can reset and repair a Network Storage Center / Network Media Center
to factory default settings if you cannot access your Network Storage Center / Network
Media Center anymore.
To restore your settings, please proceed as follows:
a) Enable the Recovery mode by clicking 'Start the recovery procedure' in the Freecom
Network Storage Assistant.
b) Turn the Network Storage Center / Network Media Center off.
c) Use a pointed object to carefully press the 'Reset' button. It is located next to the AC
power slot on the back of the Network Storage Center / Network Media Center.
d) Keep the 'Reset' button pressed down and turn device on again.
e) Wait until white LED goes off (ca. 1 second), the release the 'Reset' button.
After recovery procedure is started, system and user partitions will be checked. If all
partitions are OK, you will be asked if you want to reset your device and if all user settings
should be kept or not.
If an error was found on one of the device partitions, you will get a message that an
irreparable error was found and that the device has to be restored to factory defaults.
When accepting this, the internal hard disk will be formatted and system factory defaults
will be restored.
Attention: This will delete all user data on the Network Storage Center /
Network Media Center!
46