Troubleshooting - Goldline AQL-WW-RF-PS-4 Installation & Operation Manual

Wireless remote display for aqua logic automation and chlorination

Hide thumbs

Table of Contents

Batteries dead!

Please charge now!

This display is shown briefly, immediately before the unit shuts down. The AQL-Tx-

RF-PS-x will not operate again (to protect the batteries) until it is plugged into the

charger. It can be used immediately while connected to the charger.

Can't find the "Teach Wireless" display: From the Aqua Logic control (or any

direct wired display/keypad) press the "menu" button (possibly more than once)

until "Settings Menu" is displayed. Next, press the "<" or ">" buttons (possibly

more than once) until the "Teach Wireless" display appears. If you get to the

point where "Settings Menu" appears again, then this means that the Aqua

Logic control unit is not communicating with the base receiver. Check that the 4

wire cable from the base receiver is plugged into the "wireless" connector on the

main printed circuit board. If this connector is already plugged in (for more than

30 seconds), then call Goldline Technical Service for assistance.

"Teach Wireless" failed: Ensure that the remote is powered when pressing the

button. This is indicated by any message on the display of the remote. If the

remote is powered, then the next most likely cause is that the distance between

the base receiver and the remote is too great—try moving the remote closer to the

receiver. Lastly, there may be other equipment in the neighborhood that is using

the same frequency. To see if this is the case, go to the Settings Menu/Wireless

Channel and select another channel. Note that after you change the channel you

will have to "re-teach" every wireless remote device in the system.

Unreliable communication with remote devices: The most likely cause is that

the distance between the base receiver and the remote is too great—try moving

the remote closer to the receiver. Lastly, there may be other equipment in the

neighborhood that is using the same frequency. To see if this is the case, go to

the Settings Menu/Wireless Channel and select another channel. Note that after

you change the channel you will have to "re-teach" every wireless remote device

in the system.

Wireless display/keypad not functioning (no display, no LEDs illuminated):

AQL-WW-RF-PS-x models: If the display/keypad located on the main unit is

working correctly, check that there is input power to the wireless display/key-

pad. Make sure that the wall mount power supply is plugged into an active

120VAC outlet and its output connector is plugged into the wireless remote

display/keypad.

AQL-Tx-RF-PS-x models: If the display/keypad located on the main unit is

working correctly, check that there is input power to the wireless display/key-

pad. Plug the charger into an active 120VAC outlet and its output connector into

the wireless remote display/keypad. If this doesn't work, plug charger into the

unit, plug the charger into an active 120VAC outlet, wait 5 seconds, unplug the

charger, wait 5 seconds, and then plug it back in again.