Subscribe to Our Youtube Channel
Related Manuals for Power works PW50
Summary of Contents for Power works PW50
-
Page 2: Fcc Statements
FCC Statements 1. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. - Page 3 ENGLISH...
- Page 4 FRENCH...
- Page 5 PW50 Control Panel...
- Page 6 (If a channel is not used turn the volume all the way down). MASTER volume controls the loudness of the mix through its PW50. It does not affect volume of linked PW50. This jack may also be used to connect the PW50 to a power amp with a balanced line input.
- Page 7 Channel EQ (high, low) 4kHz and above , 800Hz and below. Both jacks accept a balanced input and sends a pre-master volume output mix of POWERLINK (IN and OUT) channels. Recommended use: Linking two PW50 units together. Subwoofer Out Line Out 20Hz-150Hz.
- Page 8 PW50 Signal Flow Diagram...
Need help?
Do you have a question about the PW50 and is the answer not in the manual?
Questions and answers
There is a poor connection on the power cord where it enters the power works PW50 amplifier
Ensure the PW50’s AC cord is firmly inserted into the AC receptacle. If the power cord is damaged, including a broken protective jacket or ground pin, replace it with a new one. Always use the cable provided with the PW50 or a compatible replacement.
This answer is automatically generated