Table of Contents
Advertisement
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE GEFENPRO 10X4 DVI DUAL LINK MATRIX
•
The 10x4 DVI Dual Link Matrix does not support HDCP content.
•
Make sure that a DVI monitor is powered and connected to one of the DVI
outputs on the 10x4 DVI Dual Link Matrix before applying power. By default,
the Local EDID is read from the connected monitor and is copied to all 10
DVI inputs once the Matrix has been turned on. If a monitor is not detected
by the Matrix at power-on, a default (internal) EDID of 640x480 will be used.
This functionality can be disabled using the Secure Local EDID function
through IP control. See page 36 for more information.
•
There is no internal scaling in the 10x4 DVI Dual Link Matrix. Each monitor
attached to the Matrix must be able to display the resolutions output by the
source device(s). For maximum compatibility it is recommended that only
one common resolution be used by each source device.
•
Advanced EDID features and IP configuration features are accessible
through the RS-232 serial command set.
•
Routing and EDID features can be accessed using a Web browser using the
built-in IP control.
•
IMPORTANT: If the unit is installed in a closed or multi-rack assembly, do
not block the ventilation holes of the enclosure.
OPERATION NOTES
2
Advertisement
Table of Contents
