Chevrolet Cruse 2014 Owner's Manual page 332

sealant cannot seal the tire.
See
If the tire pressure has not
dropped more than 68 kPa
(10 psi) from the recommended
inflation pressure, inflate the
tire to the recommended
inflation pressure.
19. Wipe off any sealant from the
wheel, tire or vehicle.
20. Dispose of the used sealant
canister (2) and sealant/air
hose (7) assembly at a local
dealer or in accordance with
local state codes and practices.
21. Replace it with a new canister
available from your dealer.
22. After temporarily sealing a tire
using the tire sealant and
compressor kit, take the
vehicle to an authorized dealer
within 161 km (100 mi) of
driving to have the tire repaired
or replaced.
.
To use the air compressor to inflate
a tire with air only and not sealant:
If a tire goes flat, avoid further tire
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See
See
for other important
safety warnings.
1. Remove the tire sealant and
compressor kit from its storage
location. See
2. Unlock the air only hose (6) from
the sealant canister (2) by
pulling up on the lever.
3. Pull the air only hose (6) from
the sealant canister (2).
4. Remove the power plug (3) from
the air compressor (1).
5. Place the kit on the ground.
Make sure the tire valve stem is
positioned close to the ground
so the hose will reach it.
6. Remove the tire valve stem cap
.
by turning it counterclockwise.
or
.