Honda 2003 CR-V Owner's Manual page 292

Main Menu
Table of Contents
Lights
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ''TOP.''
7. Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Turn on the headlights to test the
new bulb.
288
Maintenance
Replacing a Front Side Marker/
Turn Signal Light Bulb
1. Open the hood. The front side
marker/turn signal light is next to
the headlight bulb.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the burned out bulb straight
out of its socket. Push the new
bulb straight into the socket until
it bottoms.
4. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
BULB
5. Test the lights to make sure the
new bulb is working.