Honda 2003 CR-V Owner's Manual page 116

Main Menu
Table of Contents
Power Windows
Auto Reverse
If the driver's window runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
Any impact due to road conditions
may cause the auto reverse function
work unexpectedly on the closing
window. If it happens frequently,
there is a problem with your power
window system. You should have
your vehicle inspected by your
dealer. You can still close the
window by pulling back on the
window switch lightly and hold it.
112
Instruments and Controls
If your vehicle's battery is
disconnected or goes dead, or the
driver's window fuse is removed, the
AUTO function will be disabled. The
power window system needs to be
reset after reconnecting the battery
or installing the fuse. You should do
the following.
1. Start the engine. Push down on
the driver's window switch until
the window is fully open.
2. Pull back on the driver's window
switch to close the window
completely, then hold the switch
for a second or two more.
If the power windows do not operate
properly after resetting, have your
vehicle checked by a Honda dealer.