Standard Or Mini Pendant Mount - D-Link DCS-6815 User Manual

Section 2 - Installation

Standard or Mini Pendant Mount

Follow the steps below to mount the camera enclosure with the
pendant mount.
1. Make a cable entry hole on the wall to recess the cables.
Alternatively, cables can be threaded through the cable entry hole
on the mounting plate.
2. To prevent insects from entering the pendant mount, you may
block the cable entry hole with the supplied sponge in two different
ways. (See figures 1 and 2.)
3. Thread the cables through the pendant mount and affix the pendant
mount on the wall with screws and screw anchors (not supplied).
4. Attach the waterproof collar to the pendant mount.
5. Thread the cables through the cap and affix it to the pendant mount
with the supplied screws and washers.
6. Connect the cables to the camera enclosure. Attach the camera
enclosure to the mount and affix it with the supplied bolt.
Note: After threading the cables, please block the cable entry hole with
the supplied sponges to prevent insects from entering the tube.
D-Link DCS-6815/6817/6818 User Manual
Sponge
Figure 1
Sponge
Figure 2
14