Advertisement
Read and Understand the entire Nu-Flame Manual prior to use.
Make certain to inspect the package thoroughly. Carefully remove and unwrap your Nu-Flame fireplace.
Your fireplace will have the following components:
1. Stainless Steel Base (with 4 stand-off/thumb screw sets)
2. Black High Heat Powder Coated Base Cap (1 each)
3. Stainless Steel Burner
4. Glass Wind Screens/Legs (2 each)
5. Dampener tool
You may wish to purchase a funnel for pouring fuel into the burner
635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
SETUP INSTRUCTIONS FOR ARDORE
http://shop.bluworldusa.com · www.nu-flame.com
Unscrew and remove the nut from each
standoff/thumb screw set. Leave the thumbscrews
attached to the standoffs.
Thread the screw on each standoff into the holes on
the base (2 on each side). Thread and tighten the
nuts onto each screw from inside the fireplace base.
Unscrew and remove the thumbscrews from the
standoffs.
Tip the fireplace base on its side to attach the glass
panels. Align each glass wind screen/leg panel with
the holes on the base; the holes are closer to the
edge of the glass at the bottom of the fireplace
(refer to product photo on page 1).
Advertisement
