Dell PowerVault MD3200 Deployment Manual page 58

Controller 1, Port 2: IP: 192.168.132.102 Subnet Mask:
255.255.255.0 Port: 3260
Controller 1, Port 3: IP: 192.168.133.102 Subnet Mask:
255.255.255.0 Port: 3260
NOTE:
No default gateway is set.
To configure the iSCSI ports on the storage array:
1 From MDSM, navigate to the Setup tab on the AMW.
2 Click configure Ethernet management ports and then select Configure
iSCSI Host Ports.
3 Configure the iSCSI ports on the storage array.
NOTE:
Using static IPv4 addressing is recommended, although DHCP is supported.
The following settings are available (depending on the configuration) by
clicking the Advanced button:
• Virtual LAN (VLAN) support—A VLAN is a network of different
systems that behave as if they are connected to the same segments of a
local area network (LAN) and are supported by the same switches and
routers. When configured as a VLAN, a device can be moved to
another location without being reconfigured. To use VLAN on your
storage array, obtain the VLAN ID from your network administrator.
• Ethernet priority—This parameter is set to determine a network
access priority.
• TCP listening port—The port number on the storage array that listens
for iSCSI logins from host server iSCSI initiators.
NOTE:
storage array controller uses to connect to an iSNS server. This allows the
iSNS server to register the iSCSI target and portals of the storage array so
that the host server initiators can identify them.
• Jumbo frames—Jumbo Ethernet frames are created when the
maximum transmission units (MTUs) are larger than 1500 bytes per
frame. This setting is adjustable port-by-port.
4 To enable ICMP PING responses for all ports, select Enable ICMP PING
responses.
5 Click OK when all iSCSI storage array port configurations are complete.
6 Test the connection by performing a ping command on each iSCSI storage
array port.
58
Appendix—Manual Configuration of iSCSI
The TCP listening port for the iSNS server is the port number the