Setup; Connecting An Sx5T Model With A Power Supply - Telular Phonecell SX5T-515C CDMA2000 1X User Manual

Fixed wireless terminal 1900 mhz cdma
Table of Contents

Advertisement

Setup

Connecting an SX5T Model With a Power Supply

Your SX5T has either a Power Supply (part #74007301) or a Battery Backup Unit
(BBU; part #74006803). If your unit uses a Power Supply, please follow the instructions
below to connect the SX5T to your AC power. If it uses a BBU, please see "Connecting an SX5T
Model With a BBU" on page 3.
To connect an SX5T model with a Power Supply:
1.
Connect the barrel connector of the power supply to the AC power input receptacle of the SX5T
- see Figure 3.
2.
Plug the AC power cord into the power supply.
3.
Plug the AC power cord into the AC Power outlet.
Hint:
If there are no emergency batteries in the SX5T, it will only power on if the AC/Battery switch is in the
AC power position - see Figure 5 on page 2 for a detailed view.
4.
Check the cellular signal strength and move the unit until you achieve the best signal
possible - see LED Status Indicators on page 8 for more information.
Figure 3 – Connect the SX5T to AC Power.
Phonecell
SX5T CDMA
®
Input Receptacle
Battery
AC Power
Position
Position
Barrel Connector
AC Power
Power
Supply
1
AC Power Cord
AC Power
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Phonecell SX5T-515C CDMA2000 1X and is the answer not in the manual?

Table of Contents