Table of Contents
Advertisement
HCD-DZ7T
Parts that require fixing using adhesive agent
The following parts on the POWER board must be fixed by using the adhesive agent (such as Sony Bond Master) as it is specified by Safety
Regulations. When any part or printed circuit board is replaced during repair work, be sure to confirm that the following capacitors and resistors
are fixed by using the adhesive agent (such as Sony Bond Master) without fail.
POWER board : • C924 and R927 (refer to below fig.)
• C913 (Push down to C903 side and so fix.)
• C910 and C930 (refer to below fig.)
• EB905 side of C903
• EB905 side of C934
• C964 and C963 (refer to below fig.)
• Space between C933 and C932
• C908 and Q901 (Don't touch IC901.)
POWER BOARD
OK:more than 8mm
NG:less than 8mm
Don't incline C924 to outside.
C924
Attention of the direction at replacement
Please defend and install the direction of the below fig in the following parts on the POWER board.
OK
R912
8
R927
POWER BOARD
NG
R912
OK:more than 3.5mm
NG:less than 3.5mm
C964
OK:more than 8mm
NG:less than 8mm
C910
C930
C963
mark this side
L931
LF902
LF901
Advertisement
Table of Contents
